USI FX100 Remote Access Portal, v.3.2.1, A11

FW 3.2.1 releases for FX100 Remote Access Portal

Fixes & Enhancements

Important Notes:
This firmware release is intended primarily to support FX100 (zero client) usage with VMware View 4.5.

If deploying the FX100 in the standard R5400 1:1 workstation environment (non-VMware), please keep at FW 3.1.2 on both FX100 and R5400 to ensure compatibility.

Version

Version 3.2.1, A11

Category

Video

Release date

17 Dec 2010

Last Updated

03 Nov 2011

Importance

Available formats

File Format:Hard-Drive
File Name:R291621.exe
Download Type:HTTP
File Size: 3 MB
Format Description:This file contains a compressed (or zipped) set of files. Download the file to a folder on your hard drive, and then run (double-click) it to unzip the set of files. Follow the instructions to complete the installation.
To ensure the integrity of your download, please verify the checksum value.
MD5:
Not available
SHA1:
Not available
SHA-256:
Not available

By downloading, you accept the terms of the Dell Software License Agreement.

Applies to
FX100 Remote Access Portal
Installation instructions
Custom Instructions for R291621.exe:

Important Notes:
This firmware release is intended primarily to support FX100 (zero client) usage with VMware View 4.5.

If deploying the FX100 in the standard R5400 1:1 workstation environment (non-VMware), please keep at FW 3.1.2 on both FX100 and R5400 to ensure compatibility.

Quick instructions for upgrading your firmware:

1. First log into the Portal Administration Web Interface

2. Select the "Upload" then "Firmware" tab.

3. Select the webpage Browse button to browse to the firmware '.all' file.

4. Select the File Upload window Open button

5. Select the webpage Upload button

6. Select the webpage OK button on the "Are you sure? This will upload a new firmware image." You will see a "This operation may take a few minutes" warning window.

7. Wait for the firmware upload to complete. The following message appears when complete: "Success Flash successfully programmed! You must reset the device for the changes to take effect."

8. Reset the Portal

Note that this firmware release can only be installed on PCoIP processors running firmware release 1.4 or greater
x
Warning: Do not turn off your computer or disconnect from your power source while updating the BIOS or you may harm your computer. During the update, your computer will restart and you will briefly see a black screen.

This driver has been tested by both the independent software vendor (ISV) and Dell on the operating systems, graphics cards, and application supported by your device to ensure maximum compatibility and performance. Details

Dell recommends applying this update during your next scheduled update cycle. The update contains feature enhancements or changes that will help keep your system software current and compatible with other system modules (firmware, BIOS, drivers and software).