LSI 9265-8i SAS RAID Card firmware

LSI 9265-8i SAS RAID Card firmware

Fixes & Enhancements

1.Dont log capacity change event post rebuild completion.
2.Log commission event only if Rebuild will start on the PD.
3.Clean up bad block list during background init/check consistency failure
4.Reverted back the changes of the issues: SCGCQ00287136 & SCGCQ00287140.
5.SATA BBM list corruption
6.Stressing test on degrade raid with drives or rebuilding on drives will cause firmware hang
7.T-bolt firmware : makes unconfigured bad (foreign) to unconfigured bad on reboot.
8.cannot make the CacheCade configured PD as unconfigured bad even pulling it out during system online.
9.Hot Spare lost after FW update
10.Pulling cable when maintainpdfailhistory=1 create wrong state in arrays.
11.Memory test does not execute when performing FW diagnostics.
12.MFC variable enableSSCWB was not getting updated when updated via megaSCU
13.Code review: DC : Set RDM_FLAGS_FUA_REQ in immediate IO path in rebuilding drive case.
14.Controller does not come up while a PD Erase is in progress_Debug Firmware


Version 23.7.0-0035, A01



Release date

19 Feb 2013

Last Updated

19 Feb 2013


Available formats

File Format:Floppy
File Name:23.7.0-0035_SAS_FW_IMAGE_APP_3.190.15-1776.exe
Download Type:HTTP
File Size: 27 MB
Format Description:This file contains a compressed (or zipped) set of files. Download the file to a folder on your hard drive, then double-click it to unzip the set of files. Follow the instructions to complete the installation.
To ensure the integrity of your download, please verify the checksum value.
File Format:Plain-Text
File Name:EndUser LicenseAgreementType S_Rev. 040512.txt
Download Type:HTTP
File Size: 11 KB
Format Description:This file format contains plain text which can be viewed with a standard text editor.
To ensure the integrity of your download, please verify the checksum value.

By downloading, you accept the terms of the Dell Software License Agreement.

Applies to
LSI 9265-8i MegaRaid SAS
Installation instructions
Use MegaCLI to flash the SAS controllers.
please unzip the MegaCLI update utility in attachment.

Command syntax: MegaCli -adpfwflash -f mr2208fw.rom -a0

Reboot will be required
Warning: Do not turn off your computer or disconnect from your power source while updating the BIOS or you may harm your computer. During the update, your computer will restart and you will briefly see a black screen.

This driver has been tested by both the independent software vendor (ISV) and Dell on the operating systems, graphics cards, and application supported by your device to ensure maximum compatibility and performance. Details

Dell recommends applying this update during your next scheduled update cycle. The update contains feature enhancements or changes that will help keep your system software current and compatible with other system modules (firmware, BIOS, drivers and software).