To update the LS module SES firmware, perform the following steps:
1. Start Array Manager on the host system by clicking Start-- Programs--
OpenManage Applications-- Array Manager-- Array Manager Console.
2. Update the SES firmware on the PowerVault 660F.
a. Click Arrays-- PV660F SubSystem-- Physical Array.
b. Right-click the controller for the subsystem you wish to upgrade and
choose Download-- SES Firmware.
c. Select all the enclosure check boxes and click Next.
d. Click Browse and locate the SES195.bin file. Click Next.
e. Click Finish and OK.
NOTE: This process takes about 8 to 9 minutes for each additional LS
the storage array. If the firmware update does not complete successfully,
the process until it does. This issue is not a hardware problem, but a
f. After download completes, right-click the PV660F subsystem in Array
Manager and choose Rescan to update the properties information.
g. Right-click the enclosure in Array Manager, choose Properties, and
verify that it is using SES firmware version 1.9.5. If it is not, repeat
the download procedure.
h. Physically remove the primary LS module to cause failover.
i. Right-click the PV660F subsystem in Array Manager and choose Rescan
to update the properties information.
j. Right-click the enclosure and choose Properties to verify its
firmware level is also at version 1.9.5. If it is not, repeat the
k. Replace the LS module that you removed. If you have multiple
enclosures, you must verify the firmware level on every LS module
in the subsystem, one at a time.