PowerConnect,M6220,M6220S,V5.1.0.1,A33

Fixes and Enhancements:

Fixes
- M6220 crashes when issuing command "show interfaces switchport po1"
- Cannot apply ACL on VLAN out bound direction from GUI
- Default VLAN cannot be made static from GUI
- Incorrect SFP interface log messages on stack
- SNMP management IP address can only be set from WebUI and lost after reboot.
- Simple mode In-band IP address missing after reboot.
- ARP entries are purged for unknown reason
- OOB Static IP unreachable after stack failover
- http[s] authentication against RADIUS only allows privilege level 1 access
- SNMP v1/2 community manager address no longer functions with network address.
- Switch service tag not displayed by show system id command
- CLI commands are not authorized after Password Recovery
- LINK UP on all interfaces during POST
- FCoE -M8024-k setting TSA map to link strict and assigning bandwidth allocation to TC
- Switch GUI forcing 100Mb speed on External ports when cloning port configurations
- PowerConnect M6348/General port GUI issue
- M6348 - service tag not displayed in GUI
- email addresses with underscore "_" are rejected
- phone port configuration macro incomplete

Enhancements
- IGMP Snooping Improvements
- IP Multicast Enhancements
- Support for B1 CPU - only on 8100 series
- New Browser Support
> Mozilla Firefox 14
> Internet Explorer 9
> Google Chrome 21
- Static Route Maximum Increased to 512 (for all switches except for M6220 series)
- USB Auto-configuration expanded for multiple MAC Address support
- Ability to reset stack port counters
- Increased Maximum number of dot1x clients per port to 24
- Commands to remove signed certificates/Keys
- Support for Additional transceivers/optics