Dell PowerVault NX3300 Identity Module

For motherboard replacement of PowerVault NX3300 only!

Fixes & Enhancements

Fixes: N/A

Enhancements: N/A


Version 1.00, A00


Lifecycle Controller – Legacy

Release date

22 Aug 2012

Last Updated

11 Sep 2014


Available formats

File Format:Application
File Name:RYKFY_NX3300CustBSU_1_0.exe
Download Type:HTTP
File Size: 202 KB
Format Description:Application
To ensure the integrity of your download, please verify the checksum value.

By downloading, you accept the terms of the Dell Software License Agreement.

Applies to
Installation instructions
********* install instructions for "Customer Board Service Utility Identity Module" *****

1) Ensure that the IdentityModule's exe file has 'BSU' in its file name.
Caution: The exe file name without 'BSU' ( Board Service Utility) will fail to update if upload is attempted after motherboard replacement.
error message: RAC0142: The firmware image file is not valid for iDRAC firmware update.
2) Extract out the .pm file from the zip pack exe in this release.
3) Login into iDRAC GUI.
4) Navigate to 'iDRAC firmware update' link located on left pane.
5) Upload the .pm file. Wait for iDRAC reboot to complete.
6) Reboot the system.
7) Verify the Branding changes ( on iDrac GUI and System) requested in this .pm file.

Reboot will be required
Warning: Do not turn off your computer or disconnect from your power source while updating the BIOS or you may harm your computer. During the update, your computer will restart and you will briefly see a black screen.

This driver has been tested by both the independent software vendor (ISV) and Dell on the operating systems, graphics cards, and application supported by your device to ensure maximum compatibility and performance. Details

Dell recommends the customer review specifics about the update to determine if it applies to your system. The update contains changes that impact only certain configurations, or provides new features that may/may not apply to your environment.