- Notes, cautions, and warnings
- Overview
- Technical specifications
- Getting started with NVMe PCIe SSD
- Replacing and configuring hardware for NVMe PCIe SSD adapter
- Driver installation
- Downloading NVMe PCIe SSD drivers
- Installing or upgrading NVMe PCIe SSD driver for Microsoft Windows Server 2008 R2 SP1, 2012, 2012 R2, and 2016
- Installing or upgrading NVMe PCIe SSD driver for Red Hat Enterprise Linux or SUSE Linux Enterprise Server
- Installing or upgrading NVMe PCIe SSD driver for VMware
- Configuring and managing your NVMe PCIe SSD adapter
- Troubleshooting
- Self-Monitoring Analysis and Reporting Technology errors
- Ungraceful system shutdown or power loss
- General errors
- NVMe PCIe SSD description is truncated
- Software RAID array created by using PCIe SSDs is not detected after SLES 11 is rebooted
- NVMe PCIe SSD is not displayed in device management in operating system
- Cannot update firmware by using Dell Update Package (DUP)
- Linux fails to boot and prompts for the root password
- I/O device error on write to NVMe PCIe SSD
- NVMe PCIe SSD performance measurement not optimal
- In Windows Server, OpenManage Server Administrator does not detect PCIe NVMe devices
- System is unable to inventory or manage NVMe PCIe SSDs from HII utility
- Getting help
Dell PowerEdge Express Flash NVMe PCIe SSD Adapter User’s Guide
Linux fails to boot and prompts for the root password
- Cause
- A stale volume mount point is still present after a device removal or cryptographic erase.
- Solution
- Perform the following steps to recover from this situation:
- Enter the root password to enter maintenance mode.
- Remount the root filesystem as read-write using the following command: mount -orw,remount/.
- Manually edit /etc/fstab to remove the nonexistent device entry.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\