Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Premier Sign In Partner Program Sign In
Contact Us

Dell PowerEdge M630 Systems (VRTX Enclosure) Owner's Manual

PDF

Removing the optional IDSDM card

Prerequisites

CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that came with the product.

  1. Follow the safety guidelines listed in safety instructions section.

  2. Keep the Phillips #2 screwdriver ready.

  3. Follow the procedure listed in After working inside your system.

  4. If installed, remove the internal USB key.

  5. If installed, remove the SD card(s).

Steps

  1. Remove the two screws securing the IDSDM card to the system board.
  2. Remove the SD card slot bracket.
    CAUTION: To prevent damage to the IDSDM card, you must hold the card only by its edges.
  3. Lift the card up and away from the system.
    Figure 1. Removing the optional IDSDM card
    This figure shows removing the optional IDSDM card.
    1. IDSDM card
    2. screw (2)
    3. SD card slot bracket
    4. PCIe mezzanine card support bracket
    5. IDSDM card connector on the system board
    6. standoff (2)

Next steps

  1. Install the IDSDM card.

  2. Follow the procedure listed in the After working inside your system section.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\