Force 10 - Link connectivity for DAC (Twinax) cables on Force 10 switches.

Force 10 - Link connectivity for DAC (Twinax) cables on Force 10 switches.



Article summary: This article explains how to resolve connectivity issues with DAC (Twinax) cables.


When using DAC (Direct attached copper, also known as Twinax) cables, you may run into link connectivity issues when not using cr4 auto negotiation. This is resolved by enabling cr4 auto negotiation, which is not enabled by default. The example below shows how to do this on interface 37 on unit 0, and then saves the configuration.

Ftos>enable

Ftos#config

Ftos(config)#interface fortyGigE 0/37

Ftos(config-if-fo-0/37)#intf-type cr4 autoneg

Ftos(config-if-fo-0/37)#end

Ftos#write memory

Note: This command is only applicable on Forty-Gigabit Ethernet interfaces.

To remove the above configuration run the following command in the interface configuration.

Ftos(config-if-fo-0/37)#no intf-type cr4 autoneg




文章 ID: SLN295403

上次修改日期: 04/21/2016 04:14 AM


為本文評分

準確
實用
易懂
這篇文章對您有用嗎?
傳送意見反應
評語中不得包含下列特殊字元:<>()\
很抱歉,我們的意見回饋系統目前關閉中。請稍後再試。

感謝您的寶貴意見。