Omitir para ir al contenido principal
  • Hacer pedidos rápida y fácilmente
  • Ver pedidos y realizar seguimiento al estado del envío
  • Cree y acceda a una lista de sus productos
  • Administre sus sitios, productos y contactos de nivel de producto de Dell EMC con Administración de la empresa.

Número del artículo: 000138339


Microsoft iSCSI Initiator source IP address incorrect in persistent target or favorite targets details

Contenido del artículo


Síntomas


Article Summary:  This article provides information about incorrect Microsoft iSCSI Initiator source IP addresses


 

Issue:

After a host system reboot, when looking up the details of an iSCSI Initiator persistent target or a favorite
target, the source IP address may show another network interface (NIC)'s IP address on the host system.

 

Solution:

Per Microsoft, if connection to an iSCSI target is confirmed successful using the correct source IP address,
it is safe to ignore the error condition. To confirm that all persistent target IP addresses are correct, open
a command prompt and run the 'iscsicli SessionList' command to review the settings from there.

 

Additional Information:

An example of this could be seen when setting up targets with Multipath I/O (MPIO) and assigning 2 NICs

as iSCSI source IP addresses, such as 192.168.0.10 & 192.168.0.11. Prior to reboot, all the details for source

IP addresses are displayed as correct. After reboot, however, the target details show a source IP address from

one of the other NICs in the server, such as a Production/Management LAN NIC IP address of 10.0.0.1.

 

This particular issue has been reported from iSCSI Initiator versions 2.05 through v.2.08, at the earliest, and
is known to exist through to Windows Server 2008 R2.

Further reading on this condition may be found at:

http://social.technet.microsoft.com/Forums/en/winserverfiles/thread/d10d87c9-7361-4f0a-8ffe-5c877e6f209d 

http://support.microsoft.com/kb/2015340

 

Propiedades del artículo


Producto comprometido

Servers, PowerEdge, PowerVault, Microsoft Windows 2008 Server R2, Microsoft Windows 2008 Server Service Pack 2

Fecha de la última publicación

10 abr 2021

Versión

3

Tipo de artículo

Solution