Interpreting LCD and Embedded Diagnostic (ePSA) event messages

Interpreting LCD and Embedded Diagnostic (ePSA) event messages

The server LCD presents an error message, or an error message is generated when running the Enhanced Pre-Boot System Assessment (ePSA).

Refer to: Dell Event Message Reference

The Event Message Reference contains the error and event information generated by firmware and other agents that monitor system components. These events might be logged, presented to the user on one of the system management consoles, or both logged and displayed.

Additional Information:

To run the Embedded System Diagnostics (also known as Enhanced Pre-Boot System Assessment).
  1. As the system boots, press <F11>.
  2. Use the up and down arrows keys to select System Utilities -> Launch Dell Diagnostics

Article ID: SLN288656

Last Date Modified: 04/04/2017 05:33 PM

Rate this article

Easy to understand
Was this article helpful?
Yes No
Send us feedback
Comments cannot contain these special characters: <>()\
Sorry, our feedback system is currently down. Please try again later.

Thank you for your feedback.