Note: Remove any jobs from the center output tray, and close the multipurpose feeder cover before opening the front cover
Make sure that the printer is turned off
Push the side button and open the front cover
Pull up on the belt release levers and rotate the belt unit up as shown in the illustration
Caution: Do not touch the inside of the printer. Some parts may be hot. Allow time for the printer to cool before attempting to remove parts in this area
Hold both sides of the belt unit with both hands and pull up the left side of the unit until the peg on the left side comes out of the groove. Then, shift the belt unit to the right and remove the unit from the printer
Click the button below to Tweet feedback or request assistance on anything in the above article
Quick Tips content is self-published by the Dell Support Professionals who resolve issues daily. In order to achieve a speedy publication, Quick Tips may represent only partial solutions or work-arounds that are still in development or pending further proof of successfully resolving an issue. As such Quick Tips have not been reviewed, validated or approved by Dell and should be used with appropriate caution. Dell shall not be liable for any loss, including but not limited to loss of data, loss of profit or loss of revenue, which customers may incur by following any procedure or advice set out in the Quick Tips.