Remove, Clean, and Replace the Feed Rollers on the 2330d or 2330dn Laser Printer

Remove, Clean, and Replace the Feed Rollers on the 2330d or 2330dn Laser Printer


  1. Switch the printer off
  2. Remove the paper tray
  3. Turn the printer on to its side


  4. Open the blue plastic duplex tray to expose the pickup assembly. If the duplex tray is opened to 90° it will come loose from its mounting points. Only open the tray as far as is shown



    If the tray becomes detached follow this article to reseat it
  5. Pass the pickup arm through the opening in the duplex tray


  6. Peel the rubber tyres off the pickup assembly wheels


  7. Thoroughly clean and dry the tyres before refitting them to the pickup assembly
  8. If paper feed issues persist after cleaning, fit new or known good tyres if available. If no new or known good parts are available turn the tyres inside out to expose a fresh surface to the paper



If you require further assistance or wish to give us feedback, please engage our technical team on Twitter.




Article ID: SLN286270

Last Date Modified: 08/22/2018 03:28 PM


Rate this article

Accurate
Useful
Easy to understand
Was this article helpful?
Yes No
Send us feedback
Comments cannot contain these special characters: <>()\
Sorry, our feedback system is currently down. Please try again later.

Thank you for your feedback.