|Article Summary:||This article provides information on removing and replacing the Belt Unit on the 3110cn Dell Laser Printer|
|Before performing any of the following procedures, read and follow the safety instructions in your Owner's Manual|
|Make sure nothing touches or scratches the surface (black-colored film) of the belt unit. Scratches, dirt, or oil from your hands on the film of the belt unit may reduce print quality|
|To protect the drums of the print cartridges against bright light, close the front cover within 5 minutes. If the front cover remains open for more than 5 minutes, print quality may deteriorate|
Dell belt units are available only through Dell. To order by phone, see your Owner's Manual.
Dell recommends Dell belt units for your printer. Dell does not provide warranty coverage for problems caused by using accessories, parts, or components not supplied by Dell.
|1.||Removing The Used Belt Unit|
Note: Remove any jobs from the center output tray, and close the multipurpose feeder cover before opening the front cover
Caution: Do not touch the inside of the printer. Some parts may be hot. Allow time for the printer to cool before attempting to remove parts in this area
|2.||Installing A New Belt Unit|
Click the button below to Tweet feedback or request assistance on anything in the above article
Article ID: SLN291029
Last Date Modified: 04/14/2014 12:00 AM
Thank you for your feedback.