How to block sender and domains in Exchange 2013

How to block sender and domains in Exchange 2013


Article Summary: How to block sender and domains in Exchange 2013



To replace the existing values, run the following command:
Set-SenderFilterConfig -BlockedSenders <sender1,sender2...> -BlockedDomains <domain1,domain2...> -BlockedDomainsAndSubdomains <domain1,domain2...>

To add or remove entries without modifying any existing values, run the following command:
Set-SenderFilterConfig -BlockedSenders @{Add="<sender1>","<sender2>"...; Remove="<sender1>","<sender2>"...} -BlockedDomains @{Add="<domain1>"

To verify that you have successfully configured blocked senders, do the following:

Run the following command:
Get-SenderFilterConfig | Format-List BlockedSenders,BlockedDomains,BlockedDomainsAndSubdomains

Verify the values displayed are the values you configure
 


Quick Tips content is self-published by the Dell Support Professionals who resolve issues daily. In order to achieve a speedy publication, Quick Tips may represent only partial solutions or work-arounds that are still in development or pending further proof of successfully resolving an issue. As such Quick Tips have not been reviewed, validated or approved by Dell and should be used with appropriate caution. Dell shall not be liable for any loss, including but not limited to loss of data, loss of profit or loss of revenue, which customers may incur by following any procedure or advice set out in the Quick Tips.

Artikel-ID: SLN289417

Senast ändrad: 02/18/2014 12:00 AM


Betygsätt den här artikeln

Korrekt
Användbart
Lätt att förstå
Var den här artikeln till nytta?
Ja Nej
Skicka dina synpunkter
Kommentarer får inte innehålla följande specialtecken: <>()\
Vårt feedbacksystem är tyvärr ut funktion just nu. Försök igen senare.

Tack för dina synpunkter.