База знаний

Latitude E7450: Unable to Configure One or More Devices After Imaging Via SCCM

Windows Was Unable to Configure One or More Devices

Latitude E7450 user's issue was seen after PXE boot, after the Wim is applied, and AFTER the Microsoft System Center Configuration Manager (SCCM) PE Environment loads and applies drivers. The system then boots in to a windows environment to configure devices BEFORE going back to the PE environment to install applications. This is where the user reported an error stating Windows was unable to configure one or more devices. A driver issue was determined to exist with one of the Drivers in the E7450 Driver CAB.

Driver Update Required

Research has determined that if you disable the Media Card in the BIOS, that when you first initialize the unit the system will fully image without error.

Dell has identified the driver as the root cause: E1D network driver (version earlier than Updated drivers can be found as listed below:

Related Article

Latitude Exx50/xx50 series Network Interface Controller (NIC) not initializing in Windows Preboot Environment

Код статьи: SLN297519

Дата последнего изменения: 05/25/2018 10:49 AM

Оцените эту статью

Просто понять
Помогла ли вам эта статья?
Да Нет
Отправьте нам свое мнение
Комментарии не должны содержать следующие специальные символы: <>()\
К сожалению, наша система обратной связи в настоящее время не работает. Повторите попытку позже.

Благодарим вас за отзыв.