未解決
2 Intern
•
764 メッセージ
0
1294
Data Domain:Link Aggregationの構成について
DD6300/DD6800にネットワークを拡張してLink Aggregationの構成を検討しています。
10Gは標準ポートと拡張ポートを合わせると計8ポートになります。
何かの資料でLACPで構成できるポート数は4ポートまで記載があった記憶があります。
1)Data Domainの仕様上、LACPで構成できる eth の数に上限はあるのでしょうか。
2)LACPが構成できる eth の数はモデルによって異なるのでしょうか。
例
6300:LACP(4Port)
6800:LACP(8Port)
3)LACPが構成できる eth の上限数が記載されている情報は公開されていますでしょうか。
どうぞよろしくお願い致します。
ayas
Moderator
Moderator
•
6.7K メッセージ
1
2019年4月22日 23:00
RB-7716さん
いろいろ探したのですが上限の情報はなかったです・・・・
KBには以下の記述があるので少なくともeth2 and eth3の使用はできそうです。
The onboard links (eht0 and eth1) have only recently been allowed to be added. Older installations of the Data Domain software may not allow those two links to be aggregated.
To specify aggregation of eth2 and eth3 in the virtual interface veth0 one of the following commands would be used:
306105 : Setting up Link Aggregation
古い資料ですがLink Aggregationの情報があるので参考にしてください。
https://support.emc.com/docu48800_Detailed-Link-Aggregation-Configuration.pdf?language=en_US
Page 11 参照
なおよく知る人が実際にポート選択をしたところ3つ可能だったとのことでした。
ForzaRed
175 メッセージ
0
2019年4月23日 00:00
DDOS 5.2 までは上限に「4」と記述がありましたが、5.4 からは上限の記述が無くなっているので、Ayaさんの認識で相違ないですね。
モデルによって構成できるNICの数に違いがあるとは思いますが。
A maximum of four Ethernet ports can be configured as interfaces for link aggregation.
https://support.emc.com/docu49778_Data-Domain-Operating-System-5.2-Initial-Configuration-Guide.pdf?language=en_US
Two or more Ethernet ports can be configured as interfaces for link aggregation. https://support.emc.com/docu50973_Data-Domain-Operating-System-Initial-Configuration-Guide-5.4.pdf?language=en_US