fengzhang
2 Bronze

关于cisco光纤交换机write erase问题

跳至解决方案


今天对CISCO9124光纤交换机清空配置,结果交换机起不来了,串口线也没有输出。

敲了下面3条命令:

write erase

write erase boot

reload

不知又没高手遇到过这种情况啊?谢谢!

0 项奖励
1 解答

已接受的解答
Roger_Wu
5 Rhenium

Re: 关于cisco光纤交换机write erase问题

跳至解决方案
0 项奖励
5 回复数
Roger_Wu
5 Rhenium

Re: 关于cisco光纤交换机write erase问题

跳至解决方案

这个问题Cisco文档里有描述:

By issuing the write erase command and the reload command, you restore the switch settings to their factory defaults. This sequence also restores the redundancy mode setting for the power supplies back to the redundant mode (default).


Depending on the type of power supply, the input voltage, and the number of modules (line cards) in the chassis, the redundancy mode may prevent the line cards from being powered on after a system reboot (see the "Power Supply Configuration Modes" section on page 11-10). If you use this sequence, the commands that apply to the powered down line cards will not be enforced on the switch (and will not be part of its running configuration).


If using the write erase and reload command sequence before rolling back to a saved configuration, follow these steps:


Step 1 Manually change (if originally configured) the redundant mode configuration to combined mode.
Step 2 Wait until all modules are back online. The module status displays ok in response to the show module command.
Step 3 Roll back to the saved configuration (see the "Rolling Back to a Previous Configuration" section on page 9-7).


LZ试一下手动将Power Supply的模式改到combined mode看看。另外write erase boot后交换机就回到出厂设置了,admin password也需要重设。

0 项奖励
fengzhang
2 Bronze

Re: 关于cisco光纤交换机write erase问题

跳至解决方案

谢谢你的回复.

但是,现在的问题的是串口都没有输出,这个怎么搞啊。。。

0 项奖励
Roger_Wu
5 Rhenium

Re: 关于cisco光纤交换机write erase问题

跳至解决方案
0 项奖励
fengzhang
2 Bronze

Re: 关于cisco光纤交换机write erase问题

跳至解决方案

谢谢!

0 项奖励
cxemc
3 Zinc

Re: 关于cisco光纤交换机write erase问题

跳至解决方案

曾经重启就好了。。。。俺也没弄懂原理。

0 项奖励