Consul Sulla
1 Nickel

Alienware Aurora R6 no signal on startup

Hi,

When I start up my Aurora R6 I get no signal. I've tested both my HDMI cable and monitor with other devices, and they both work. The PC turns on, but does not send any signal. Does anyone know any solutions to this problem.

Thanks

Labels (3)
0 Kudos
3 Replies
JOcean
4 Ruthenium

Re: Alienware Aurora R6 no signal on startup

The following link may help. Have you tried a reset? Disconnect the battery and unplug the adapter. Then press and hold the power button for 30 seconds. Now reconnect everything and try again. In the following link try the steps suggested by Vintage 1983.

https://www.dell.com/community/Alienware-General-Read-Only/Alienware-Aurora-boots-up-but-no-display-...




-Forum Member since 2016
-I do not work for Dell
-A user helping other users
-If you like an answer please click on thumbs up
-If a reply is a solution to your problem please click on Accept as Solution
Gaming on a home built ASUS Z170K i5 6600
Real work on an Inspiron 15 5575
0 Kudos
Highlighted
Consul Sulla
1 Nickel

Re: Alienware Aurora R6 no signal on startup

 I have tried that. There is new info though, I tried turning it on again a little later, the monitor came on and I had visual. But even though it all started up correctly this time there was still problems. Like the mouse would freeze occasionally and the lights on the keyboard were flickering. I tried to use this time to check if the drivers needed updating, but while I tried this my monitor lost connection to my computer again. Now I'm back where I started.

0 Kudos

Re: Alienware Aurora R6 no signal on startup

Sounds like a GPU Failure, or some hardware failure.. Try to get to run diagnostics.

0 Kudos