So I have the latest Windows 10 updates (1809), the latest Dell and Alienware drivers for everything, latest graphics drivers, latest BIOS...
However, the AWCC (Alienware Command Center) seems to break after an update yesterday (not sure what version it was) and the AlienFX entirely doesn't load or work, all the lights on laptop stuck on light blue. Essentially, the following happens:
AWCC only loads the Library and Fusion tabs
The Fusion tab sits in a "loading" state forever and if you click on the Temperature or the Power buttons, AWCC entirely crashes with no error message or popup
The keyboard and all side lights load up but I cannot change or enable/disable them, even with keyboard buttons. It stays permanently on light blue.
Tried to install all versions from Dell's AWCC driver website, nothing helps. Think it is not a hardware fault because through installation the lights changes in rainbow for a few seconds.
Waiting for help, have no more strength trying to fix this issue... 😥
I got the same problem. I had to reset my computer after that update. AWCC could not connect to internet so I could not overclock my cpu. -Alienware 17 R5
Did you try to reinstall the Alienware OC Controls after updating AWCC? The current version of AWCC seems to need the latest OC Controls package to work properly. Latest version should be available in Drivers & Downloads on the support page for your system.
Can you give us a better explanation of what the issue is and how it started?
Dell | Alienware Technical Support
Opening your case does not void your warranty! Check out Alienware Artificial Intelligence
I can't always reply to PM's, if you need extra assistance visit: