Unsolved
This post is more than 5 years old
6 Posts
0
31178
M600 iDRAC update failed
I attempted a firmware update on one of the M600 iDRAC cards I have and I did it through the web interface with the image file. All my other M600 iDRAC cards updated fine, but this one I told it to update and after it uploaded the file it then should have went to the progress screen and it never did. Now when you try and visit the iDRAC web interface you get the below message.
Access Error: Target device firmware is being upgraded and not currently available.Please try again after update completes.
How do I go about fixing this. Thank you in advance.
doodleface
6 Posts
0
September 24th, 2013 21:00
It has been well past an hour and it is still doing this. How do I go about resetting the iDRAC. Thank you for your help.
DELL-Shine K
4 Operator
4 Operator
•
3K Posts
0
September 24th, 2013 21:00
We see this issue mainly when we traverse to different page while update is in progress or update is interrupted in between. Can you wait for 1 hour and try again. You should not see this issue after one hour. If you are still seeing this issue after one hour reset iDRAC and try again.