gert_67
2 Bronze

problem with M1000e chassis

Jump to solution

Hi,

I'm new to Dell blades. We received a Dell M1000e blade chassis with 8 M600 blades that I'm setting up for a test environment. It has 2 of the blades installed at this moment.

When I power on the chassis the display only says: "Enclosure Management initializing..." and the the LED is blinking in orange (red?). Nothing else happens. The VGA screen does not have any output.

I wanted to use the LCD to configure an IP address for the CMC. Where and how can I see what is wrong?

fyi the chassis has 3 I/O modules: 
- A1 and A2 have a passthrough Ethernet IO Module
- B1 has a M6220 Ethernet switch.
- The blades have no mezzanine cards 

Thanks in advance for any help.

Kind Regards, 

0 Kudos
1 Solution

Accepted Solutions
gert_67
2 Bronze

Re: problem with M1000e chassis

Jump to solution

I don't seem to be able to delete this thread but it is solved. I just plugged in the power. But when I pressed the power button to turn it off and then pressed it again to turn it on the display worked.

So this question can be ignored.

If there is a moderator: please delete it!

View solution in original post

1 Reply
gert_67
2 Bronze

Re: problem with M1000e chassis

Jump to solution

I don't seem to be able to delete this thread but it is solved. I just plugged in the power. But when I pressed the power button to turn it off and then pressed it again to turn it on the display worked.

So this question can be ignored.

If there is a moderator: please delete it!

View solution in original post