Host Initiator configuration

try Clariion procedure generator

Home > Support > Product and Diagnostic Tools > CLARiiON Tools > CLARiiON Procedure Generators

This is from the Navisphere administrators guide. It starts talking about the "failover setup wizard" at page 100.

https://powerlink.emc.com/nsepn/webapps/btg548664833igtcuup4826/km/live1/en_US/Offering_Technical/Technical_Documentation/300-003-511.pdf

It states that the specific host settings are found in this document, The Installation Roadmap for Clariion Storage Systems:

https://powerlink.emc.com/nsepn/webapps/btg548664833igtcuup4826/km/live1/en_US/Offering_Technical/Technical_Documentation/069001166.pdf

Hope this helps.

Message was edited by:
SANDoozer

Yes. Failover mode, Array Comm Path, Initiator Type. I have the proceedure generator but the new version dosen't have the option to connect a new host.

Are you refering to failover settings?

I looked in this document. It says to check the document called "EMC CLARiiON Open Systems Configuration Guide For CX3-Series and CX-Series Storage Systems"

Of course, I can't find that anywhere...

Winner Winner... Chicken Dinner!

Thanks for all the responses.

Also see Primus article emc99467 for complete setting and and notes about failover setting:

http://knowledgebase.emc.com/emcice/documentDisplay.do?docType=1006&clusterName=DefaultCluster&resultType=5002&groupId=1&page=&docProp=$solution_id&docPropValue=emc99467&passedTitle=null

glen

The customer CPG has been replaced with the support pages

See http://emc.com/cx3support and http://emc.com/cx4support

Gearoid

Thanks GearoidG. Is this the final product ? I just went through "installing" a new Solaris system, and the web page "HBAs to Install" does not list Emulex HBAs.