This post is more than 5 years old
38 Posts
0
8076
Who has the 03.24.040.5.019.mif for CX series recovery image file？I can't find it in powerlink services partner web
Be cause I has some problems in the "ODBS_INVALID_REV_PANIC" error issue ,an old CX3-40f strorage system gones rolling reboot long time , It need the 03.24.040.5.019.mif file re-image SPs out this problem ，but I can't find it on the services partner web ,who can give me a download link?
checking the boot logs，that “WARNING: Disk 2 Failed" word it means the vault disks disk 2 failed ，it needs rebuild， both SPs in a rolling reboot again and again
************************************************************
* Extended POST Messages
************************************************************
WARNING: Disk 2 Failed TUR
************************************************************
DDBS: K10_REBOOT_DATA: Count = 4
DDBS: K10_REBOOT_DATA: State = 0
DDBS: K10_REBOOT_DATA: ForceDegradedMode = 0
DDBS: SP B Normal Boot Partition
DDBS: MDDE (Rev 200) on disk 1
DDBS: MDDE (Rev 200) on disk 3
DDBS: MDB read from both disks.
DDBS: Chassis and disk WWN seeds match.
DDBS: Second (secondary) disk needs rebuild.
DDBS: First disk is valid for boot.
int13 - READ PARAMETERS (1569)
int13 - CHECK EXTENSIONS PRESENT (1570)
int13 - GET DRIVE PARAMETERS (Extended) (1571)
int13 - READ PARAMETERS (1618)
int13 - CHECK EXTENSIONS PRESENT (1619)
int13 - GET DRIVE PARAMETERS (Extended) (1620)
...
Wyman_chen
38 Posts
0
September 12th, 2013 22:00
I was contact EMC technical support to fixed the problem ,thank you !
I has re-image 03.24.040.5.019.mif revocer boot image and replace the 0_0_2 disk ,they are working good now.
Roger_Wu
4K Posts
0
September 8th, 2013 18:00
I can only find FLARE-03.24.040.5.011.mif on EMC Service Partner Web. It should also work for you.
You can speek Chinese? For further discussion, you might go to ECN Chinese forum https://community.emc.com/go/chinese.
Vipin VK
812 Posts
1
September 9th, 2013 01:00
You may request for the same from software@emc.com.
Just curious, have you tried copying image from utility partition (from boot log DDBS: First disk is valid for boot).
Vipin VK
812 Posts
0
September 12th, 2013 23:00
Did you download recovery image or was it a re-image from utility partition ?
kelleg
4.5K Posts
0
September 20th, 2013 14:00
Was your question answered correctly? If so, please remember to mark your question Answered when you get the correct answer and award points to the person providing the answer. This helps others searching for a similar issue.
glen
yage12
3 Posts
0
April 11th, 2019 06:00
I need 03.24.040.5.019.mif. could you help me ?
Please send me an email:
Look forward to your reply!!
snokohn2
3 Posts
0
July 13th, 2021 10:00
any chance you can send me the
FLARE- 05.33.009.5.186.mif
i have a downed san sp