Unsolved
This post is more than 5 years old
71 Posts
0
596
navisphere reports and verify - can they be run from command line
Hi, I would like to be be able to create the navisphere manager reports and the verify report from command line. This is so that the reports can be created without opening navisphere manager and the report would then be emailed to a User.
Is it possible to do this?
Thanks, Mark
symmariion
24 Posts
0
September 23rd, 2010 10:00
Hi Mark,
There's no single command that will create the same output information seen in the Navisphere Manager reporting tool. It's actually a combination of several navicli commands that create the reports. All of which I can not list for you on the forums.
But you can script a similar output collecting the information you care about using navicli commands. Please reference the navicli command line reference guide found on Home > Support > Technical Documentation and Advisories > Software ~ J-O ~ Documentation > Navisphere Management Suite > Maintenance/Administration for commands to get the information you need.
If this has helped pleas mark this discussion as answered.
Thanks,
Kristi