57 Posts
0
8661
Brocade SW 6520 Domain ID
I have two new Brocade Switch 6520, acting as standalone, i wont merge those
The default domain id is 1
I want to learn about the best practices to set the domain id for standalone switches, is there any advice to about brocade 6520 domain id must be greater o smaller than others? for example Brocade 6520-1 Set the domain to 3 and the other Brocade 6520-2 Set the domain id to 4.
Does it matter domain id ranking??
Do you recommend to use or leave the default id ? or change it just for best practices
Bes regards
ErikS1
18 Posts
0
October 23rd, 2018 15:00
Hi, you can leave the Domain ID at the default. It will make no difference to the switches or the protocol while running in a single switch fabric.
Regards, Erik
kikoguanabakoa
57 Posts
0
October 23rd, 2018 16:00
Thanks in advance
so I can leave sw1 as the default(1) and the other to 2? just to identify the switches, i mean 6520-1 default domain id (1) y the other 6520-2 (Domain id 2)
?????
Best regards
Ed Schulte
143 Posts
0
October 23rd, 2018 23:00
Hi, Yes that is correct. You can give the switches domain1 and 2. Should not be any problem.
Regards,
Ed
kikoguanabakoa
57 Posts
0
October 25th, 2018 07:00
I already changed the domain id.
just one more question about it
i already connected the VMAX 450FX and Host, the host is connected to N8 and my storage is connected N16,
is there any issue if a leave the Storage port to N16 and the Host to N8????
Best regards
take a look at the image
Ed Schulte
143 Posts
0
October 25th, 2018 07:00
Hi,
No issue, N8 and N16 means the speed the host and storage ports are connected to the switch.
I suggest the download the command guide for the version of FOS you are using, the commands are in there with a good explanation of the detail outputs.
Regards,
Ed