This post is more than 5 years old
28 Posts
0
663
C class blade enclosure
We have built 2 fabrics both connected to c class blade enclosures. We enabled npv on the 9124's and npiv in the edge switch. Still the cisco port wwn shows up the the flogi not the hba wwn of the blade enclosure. We are using soft zoning.
I need to do the zoning of the blade enclosures to DMX-4's.
Does any one know what could be the issue.
Message was edited by:
nandamuri
I need to do the zoning of the blade enclosures to DMX-4's.
Does any one know what could be the issue.
Message was edited by:
nandamuri
healyj
141 Posts
0
November 28th, 2017 06:00
Hi there,
In our effort s to clean up the forum, we came across your question / statement.
If the question / statement is still valid, not expired and you need an update please reach out again and we try to get it answered.
As for now we set it to “answered.”
Regards,
Jim
ConnectrixHelpe
259 Posts
0
September 8th, 2008 10:00
Thank you.
ConnectrixHelpe
259 Posts
0
September 8th, 2008 10:00
The Cisco MDS 9124 switch with SAN-OS Release 3.2(3a) is not supported as a NPIV capable switch with Hewlett Packard¿s Virtual Channel Fibre Channel (VC-FC) blade server modules.
nandamuri
28 Posts
0
September 8th, 2008 10:00
9513's
Software
BIOS: version 1.0.6
kickstart: version 3.2(3a)
system: version 3.2(3a)
9124's
Software
BIOS: version 1.0.11
kickstart: version 3.2(2c)
system: version 3.2(2c)
nandamuri
28 Posts
0
September 8th, 2008 10:00
ConnectrixHelpe
259 Posts
0
September 8th, 2008 10:00
Channel Fibre Channel (VC-FC) blade server modules?
Thank you.
nandamuri
28 Posts
0
September 8th, 2008 11:00
I will greatly appreciate it.
I got it. Thankyou.
Message was edited by:
nandamuri