Unsolved
This post is more than 5 years old
1 Rookie
•
36 Posts
0
860
adding MDS9124 to Brocade DS-300
Hi
does anyone know the best way to connect Cisco MDS 9124 to Brocade DS-300?
i would like to have the MDS as extension of the exsting zone that is on the Brocade switch.
BR
Ingvar
dynamox
1 Rookie
1 Rookie
•
20.4K Posts
1
April 8th, 2015 10:00
i would investigate if you can put MDS 9124 into NPV mode (that will wipe its' config) and if DS-300 support NPIV. This way MDS 9124 will essentially become a "pass-through" device and you would not have to mess with interop.
RobertDudley
448 Posts
0
April 22nd, 2015 07:00
You may be able to create a VSAN on the cisco with the ports you want to connect to the Brocade. Put that VSAN into inter-op mode. Connect the Cisco to the Brocade and they "should" link up. You would have to do inter-vsan routing to zone anything on the brocade to the cisco and vice versa.
ingvar oskarsson
1 Rookie
1 Rookie
•
36 Posts
0
April 28th, 2015 14:00
Thanks Dynamox and sorry for late reply, this solution did the trick for me.
BR
Ingvar