This post is more than 5 years old
5 Posts
0
777
unable to connect ibm blade trough brocade4g into mcdata fabric
Our clariions are connected through a macdata DS-24M2.
We're trying to connect an IBM blade to this fabric through 2 integrated switches brocade4g, but the link appears segmented.
The new switches have an unique domain-ID, are configured in openfabric, the port is configured in E-port, all parameters (R_A_TOV, E_D_TOV, etc.) seem compatible.
Does someone have an idea on how to merge those switches into the fabric ?
We're trying to connect an IBM blade to this fabric through 2 integrated switches brocade4g, but the link appears segmented.
The new switches have an unique domain-ID, are configured in openfabric, the port is configured in E-port, all parameters (R_A_TOV, E_D_TOV, etc.) seem compatible.
Does someone have an idea on how to merge those switches into the fabric ?
dynamox
1 Rookie
1 Rookie
•
20.4K Posts
0
October 6th, 2008 08:00
gs-PKGPW
5 Posts
0
October 6th, 2008 08:00
Interoperability matrix to make sure firmware
versions, models are supported.
you're right, we must also upgrade the mcdata, i didn't see it first time i look the matrix
yes
number 5, and no other switches have the same.
but the problem is probably we need to operate a firmware upgrade on the fabric, thanks a lot
dynamox
1 Rookie
1 Rookie
•
20.4K Posts
1
October 6th, 2008 09:00
http://forums.emc.com/forums/thread.jspa?messageID=427156
gs-PKGPW
5 Posts
0
November 6th, 2008 02:00
many thanks
Message was edited by:
gs