Unsolved
This post is more than 5 years old
1 Message
0
3131
Join Member to existing group
Hi. I just have a question. I have PS4000 San. I already did the setup. Is there a way I could join the PS4000 to an existing group without doing the initial setup. Either through the cli or gui. Thanks.
Dev Mgr
9.3K Posts
0
May 25th, 2010 11:00
Not with data in place, and there are minimum firmware version requirements before a PS4000 will be accepted into a group. Firmware 4.1.4 added support for the PS4000 and PS6000 from what I can tell. So to join a PS4000 (or PS6000) to an existing group, all members in that group need to be at least on 4.1.4 before they will accept a PS4000 into the group.
Then for the joining; I don't believe you can merge existing groups, so you'd have to reset (via SSH or serial) the PS4000 and run the setup wizard again to join it to the other group. Note: this wipes all data off of the PS4000 in case it wasn't obviously from what you have to type in to confirm the reset request.