1 Nickel

DD2500 Networking Best Practice / Config

Hi All -

IHAC with a DD2500 with the extra dual port 10GB ethernet module card (LC connections)

Currently I'm thinking to set the networking up as below

Use the 2 x 10GB connections from the card in a ifgroup for DDBoost

Use 2 of the 4 onboard 1GB connections for Management (ethMa and ethMd) in a failover setup

also make use of the ipmi port

Will the above setup confirm to a good setup?

I still have the 2 x 10G connections that I could also put into the ifgroup to give me 4 connections that

would keep the system going in case the card fails.

any advice appreciated


0 Kudos