LCC

Hi all,

Does anybody knows a command to Enable the LifeCycle Controller from remote tasks?

During upgrades i received a message that LCC was in recovery mode so i had to enable it by hand. But before we upgrade the whole environment, i would like to know if there are more LCC's in recovery mode.

So it would be nice if there is a command to do so.

Thx in advance.

0 Kudos
3 Replies

RE: LCC

Hi, thanks for the query.

You can use following racadm command to enable LC:

racadm set LifecycleController.LCAttributes.LifecycleControllerState 1

Hope it helps!

Thanks,
Shivendra

0 Kudos

RE: LCC

Thx Shivendra

I will use that to check and set the Value.

Do you know what the is reason the LCC goes into recovery mode? what causes that?

0 Kudos
Highlighted

RE: LCC

Folks on below forum (general systems management) should be able to help with that:

en.community.dell.com/.../4469

Thanks,
Shivendra

0 Kudos