i am typing this reply from the problamatic dell systme in question.
its case fans are very loud.
using SpeedFan software i enabled the option "Enable Dell support use this option on note books"
under config > options.
the restarted the speedfan software and now it is showing rpms of a lot of fans.
setting values for PWM 2 ,3,4 from 0 % to 100 % no noise increase or decrease was observed.
however changing PWM 1 the speed of two front big fans was responding to it.
changing pwm percentage of pwm5 also changed the fan 5 speed.
now i have set it to 60 % and its noise is normal. the front two fans are at 1280 RPM now /
rebooting system looses its settings ..
i also noticed one morething. when the system boots its fans are loud and speedfan shows 2900 rpm for fan 1 ( which could be settings for both front fans)..
once pwm1 value is lowered to reduce fan speed re-adjusting pwm 1 to 100 % however doesnt increases rpm to 2900 instead they are at 2250 rpm.
seems there is some controlling chip on motherboard that is damaged ?
i also flashed same bios again no luck.
but why is it giving the error that i attached in previous message about cpu 2 ram fan ? when ram fan is working ..
front diagnostic lights 1-4 are all off after it gives control to windows.
I will try booting it with 6 pin power connector removed from motherboard and second processor on the riser card ..
I booting it with 6 pin power connector removed from the motherboard but it wont turn on fully. The fans would spin for a while then it would turn off.
I tested using post card and it says 00 when powered on with single processor.. Same error code when powered up with no processor installed.. (riser card was removed from system for both tests).
But cpu was heating normally. So is vrm section ok?
I tired to check if there is short in the cpu power section by testing for short between the ground and the other pins on (4 pin connector...). Of Power socket on motherboard.
But no short was found.
Any heads up?