Unsolved
This post is more than 5 years old
306 Posts
0
37909
Master Control Board Firmware A03 problems
I just updated to A03 that was called an urgent update. Now my system hangs at the Dell boot screen for about a minute, then I get an error stating M/F USB Cable Not Connected. I hit F1 and the system boots normally. Now when I check NVidia's Control Panel, the Chassis and Firmware tab are missing. I wanted to reinstall A02 Firmware but since the Firmware update tab was missing, I couldn't.
I udated the bios to 1.05 to see if that would fix anything. It didn't. Do I need to reset my Master Control Board?
Please help
Glenn
Message Edited by atbglenn on 10-29-2008 11:28 PM
ElkWapiti
513 Posts
0
October 31st, 2008 14:00
I received a confirmation box: "Your ESA firmware is updated."
The firmware version listed is still 22.
Everything else appears the same in all respects - operation and features are unchanged.