Max and minimum height of the Dell Small Form Factor All-in-One Stand - OSS17

http://i.dell.com/sites/doccontent/shared-content/data-sheets/en/Documents/ecemea-optiplex-5040-technical-spec-sheet.pdf

3040 5040 7040 SFF

11.4 x  11.5 x 3.6
29.0 x 29.2 x 9.26

Dell S2715H  monitor
Dimensions with stand (H x W x D):
Height: 445 mm (17.52")
Width: 611.2 mm (24.06")
Depth: 196 mm (7.72") So you add 4 inches for the Computer.  

Manufacturer part M7V3M

   Dell part 452-BCMX

http://accessories.us.dell.com/sna/products/Docking/productdetail.aspx?c=ca&l=en&s=que&cs=caque1&sku=452-BCMX

Is this the same part as this:

www.dell.com/.../pc-accessories

Thanks.  I'm not sure that will work for the OS117 also.

6P8CR = OSS17 All-In-One Stand, Sales SKU = 452-BCMX, 452-BCPW, 452-BCPX, 469-5408

I cannot find any document that details the height from the desktop surface to the bottom and top reach of the monitor bracket. None of the labs here have this stand. All that is listed on its page is the setup guide. Perhaps you can see one on display at a local store and have them measure it.

So, I went out and measured one yesterday.  At it's lowest and you are right, it depends on the monitor size, but the top of the monitor when lowered was flush with the unit.  At it's lowest was at 15and 1/4 inches.