Skip to main content
Start a Conversation

This post is more than 5 years old

Solved!

Go to Solution

Voldog75

2 Posts

33298

November 18th, 2014 07:00

PERC Drivers not loading

I have a Dell T3600 I am trying to restore back to factory defaults. The Hard Drive is on the Sata/Raid controller HDD0 port, I have downloaded the PERC drivers for my computer using the service tag. When I pop in the Windows 7 disc and try to access my recovery partition on the hard, the drive is not found. I pop in the CD with the PERC drivers and I load the drivers for my system the HD still does not show up.

speedstep

8 Wizard

 • 

47K Posts

November 18th, 2014 08:00

F6 drivers must be done from floppy.

You Require F6 drivers for windows.

Windows does not support the controller natively.

You have to install IN ATA mode not AHCI mode then add drivers.

This package provides the driver for Intel C600 SCU Storage Controller and is supported on Precision T series running the following Windows Operating system Windows: Vista, Windows 7 and Windows 8 (32/64-bit).

http://downloads.dell.com/FOLDER01066332M/3/RSTe_f6_X5W2D_A02_ZPE.exe

http://downloads.dell.com/FOLDER00575801M/8/DRVR_SAS_PERC_MSM-DV6JF_setup_ZPE.exe

F6 install.  Otherwise you get STOP: 0x0000007B (parameter1, parameter2, parameter3, parameter4)

Systems Precision T3600 ,T5600 , T7600

INACCESSIBLE_BOOT_DEVICE

F6 Drivers Apply to windows only.

http://www.intel.com/support/chipsets/imsm/sb/CS-029979.htm

General information

Troubleshooting

Related Topics:
Microsoft* Knowledge Base article: Limited OEM driver support is available with F6...*

This applies to:

Intel® Rapid Storage Technology (Intel® RST)

http://support.microsoft.com/kb/916196

You press F6 to install mass storage drivers during the Windows installation process.

http://support.microsoft.com/kb/922976

Linux modprobe is something else entirely.

H310, H710, H710P, H810

http://www.dell.com/support/drivers/us/en/19/driverdetails?driverid=M20VR

This is the driver for the following PowerEdge Expandable RAID Controllers:
 
    PERC H310 Adapter
    PERC H310 Mini Monolithic
    PERC H310 Mini Blades
    PERC H310 Embedded
    PERC H710 Adapter
    PERC H710 Mini Monolithic
    PERC H710 Mini Blades
    PERC H710P Adapter
    PERC H710P Mini Monolithic
    PERC H710P Mini Blades
    PERC H810 Adapter

 

After you use the BIOS setup of a Windows 7-based computer or a Windows Vista-based computer to change the Serial Advanced Technology Attachment (SATA) mode of the boot drive to use either the Advanced Host Controller Interface (AHCI) specification or redundant array of independent disks (RAID) features, you receive the following error message when the computer is restarted: 
STOP 0x0000007B INACCESSABLE_BOOT_DEVICE

This issue occurs if the disk driver in Windows 7 or Windows Vista is disabled. This driver must be enabled before you change the SATA/RAID mode of the boot drive.

 

 

Voldog75

2 Posts

November 18th, 2014 12:00

Thank you SpeedStep! Loaded the f6_iaStor Drivers and found my drive and was able to reload my OS.

View More

View All

No Events found!

Top