Unsolved
This post is more than 5 years old
48 Posts
0
23377
How do I remove the front cover of Dimension 4600 (i assume same for all dimensions)
I want to remove the front plastic cover of my dimension 4600, so I can put a filter of the intake (inside is getting pretty dusty), but cant figure out how it comes off. Any suggestions?
Redwing634
48 Posts
0
September 29th, 2005 12:00
BigBrother
4.8K Posts
0
September 29th, 2005 12:00
Redwing634,
You are welcome. While you have the system open, you should consider cleaning out all of the dust using canned air. Do not use a vacuum cleaner. Since you are going to add a dust filter, you will need to change that filter regularly or it will cause your system to run hotter when the filter gets clogged up.
Steve
BigBrother
4.8K Posts
0
September 29th, 2005 12:00
Redwing634,
Check this link for instructions on removing the front cover panel:
<ADMIN NOTE: Broken link has been removed from this post by Dell>
Cover panel removal is not the same for all Dimension systems.
Steve
Message Edited by BigBrother on 09-29-2005 08:36 AM
rickmktg
11.9K Posts
0
September 30th, 2005 21:00
If you need help in removing the nylons from the female, I'm sure that some of us can help you out. :smileywink:
I've heard that using male nylons doesn't work as well, and you don't want to have to go get them...
rickmktg
11.9K Posts
0
September 30th, 2005 21:00
Redwing634
48 Posts
0
September 30th, 2005 21:00
rickmktg
11.9K Posts
0
September 30th, 2005 21:00
Redwing634
48 Posts
0
September 30th, 2005 21:00