I am having a plug and play configuration error. whenever i try to put a pci device in my dell dimension 4300 i get a Plug & Play Configuration error at bootup. And the pci cards that i can install successfully without getting a error i cant even install the drivers for. Windows just detects them as a PCI Device.
What is the device? What version of windows do you have installed on this system? Have you tried removing the device and installing while in windows?
I am a technician for a computer company. I was given the computer after the modem was struck by lightning and the modem had to be taken out for the computer to continue to work. I tried to install a new modem and oppon booting up with the new modem in the system it game me a Plug and Play configuration error. I have done a series of test and cannot figure out the problem. I know very little on how dell has there bios set up and i think that plays a major role in the situation
Reseat the problem 2-3 times, then boot the system into BIOS (F2).
ALT+F to default the BIOS settings
Caps/Scroll/NUM locks all on, then press ALT+E to clear the system NVRAM
Arrow down to system event log and clear the log and mark all as read.
ESC from BIOS and "save changes and exit" by pressing enter.
If this doesn't clear up the problem with a specific card, the card is likely contaminated, bad, or simply incompatible.
You can also remove all PCI devices from the MB. Reset BIOS to default configuration. Remove the nickel-sized battery on the MB for about one day to reset the CMOS. Put back the battery and the problem PCI card. Reboot PC. W2K should detect the new PCI modem.