Highlighted

Precision T7400 and diagnostic lights 3 and 4

Hello

my workstation was working fine, but does not boot anymore.

All i get is a black screen, no bios, no post, and only the diagnostic lights 3 and 4.

I looked in the manual, but this light combination isn't mentioned anywhere.

I tried to remove and put back in everything (cpu, ram, all pover cables, vga)

but nothing changes.

Only removing the ram gives me light no 1 and some beeps (memory not recognized)

I also bought some replacement memory directly from Dell (FB-DIMMS DDR2 667 ECC), but same issue.

What shoud i do?

 

Any help appreciated

Thanks

 

0 Kudos
2 Replies
speedstep
Diamond

Re: Precision T7400 and diagnostic lights 3 and 4

Remove the hard drive and test the ram one stick at a time.

You are not even getting POST.

Report Unresolved Customer Service Issues here
I do not work for Dell. I too am a user.
The forum is primarily user to user, with Dell employees moderating
Contact USA Technical Support

Get Support on Twitter @DellCaresPro

0 Kudos

Re: Precision T7400 and diagnostic lights 3 and 4

I have had the same problem, just LEDs 3 & 4 showing green. Then I replaced the RTC-Battery on the motherboard and everything worked fine again.

Try it!

0 Kudos