Highlighted
2 Bronze

Both eth0 and eth1 on not UP on Same controller

Hi

So far firmware updates are going well on all our machines.

But for one of our SAN, on Active Controller eth0 is UP and eth1 is UP in passive controller. Can we proceed for firmware update?

 

Thanks

Dinesh Pathapati

0 Kudos
1 Reply
4 Beryllium

Re: Both eth0 and eth1 on not UP on Same controller

Hello,

 Yes, that's because the active CM is using the port connection on the passive.  It's known as "Vertical Failover".

The passive controller can not actually have active Ethernet ports.

 You are fine to proceed.

Regards,

Don

0 Kudos