EqualLogic indicating update available even after updated

[GabzHenrique]

Good morning everyone.
I have been facing some difficulty with DELL EqualLogic PS6100.
When I click Check for software updade, I get the message that there is an update available.

However, I already did the firmware update, both through the GUI and the CLI. Even if I enter the Dell Storage Update Manager, no update appears and says it is updated.

Has anyone been through this or know what I need to do? I've already reinstalled the firmware and nothing worked.
I thank anyone who can help me.

[dwilliam62]

Hello, 

 What version did you upgrade to? 

 Screenshots get scanned so they don't appear immediately after posting. 

 Did you also see if a drive firmware update was needed? 

 What about SANHQ?   Did you upgrade that to current version as well?  v3.4.1? 

 Regards,

Don

[dwilliam62]

Hello, 

 I noticed on my 10.0.3 array it did the same.  There are other software packages it checks for. The HIT/ME, HIT/LE, SRM, etc.. 

 On an older array non 10.x  I got a summary 

 So the new software does not refer to the EQL firmware but likely one of the other packages.  

 Regards,

Don 

[GabzHenrique]

Thanks for your answer @dwilliam62 
I just installed the firmware, I think it is the most important.
It is strange to say that the last update was made in September 2018.
Does anyone know which one to install to update this information?

[dwilliam62]

Hello, 

 You are very welcome. 

Re: Last Update.  Not sure what you are referring to. 

 Regards,

Don