Unsolved
1 Message
0
970
Tried diskzero on Equallogic but Received Segmentation Fault
I am converting a previously active EqualLogic PS6000 SAN array to a test lab, and in the process did a diskzero on the array with the following results:
-The following drives will be Zeroed:
-Segmentation Fault
What can cause that and how do I fix it?
dwilliam62
1 Rookie
1 Rookie
•
1.5K Posts
0
December 31st, 2018 08:00
Hello,
If the array has been reset, there's no need to do a diskzero.
If not, you can do a reset (as long as it is a group with JUST that array) and return it to factory defaults.
Sounds like it might be very old firmware.
Regards,
Don