Unsolved
This post is more than 5 years old
4 Posts
0
1098
Dell Dimension 8400 Troubleshooting
On screen: No boot device available - Strike F1 to retry boot, F2 for setup utility
Back of computer: A B C D indicators are green
CR2032 battery has been removed and replaced with a new one
Strike F1: on screen message repeats
Strike F2: screen goes to setup utility
Thanks.
speedstep
8 Wizard
8 Wizard
•
47K Posts
0
April 13th, 2018 09:00
Hard Drive is dead. Time for a new one. This system is OVER 12 years old.
RoHe
10 Elder
10 Elder
•
43.4K Posts
0
April 13th, 2018 11:00
Always include version of Windows in your posts. :Idea:
Reboot and immediately press F2 to open BIOS setup. Make sure these are the current BIOS setting or change to these settings:
Date/Time: Set to current date/time
Drives 0 - 5: Make sure your boot drive is correctly recognized on SATA0 port*
SATA Mode: (aka: SATA Operation, or Drive Controller): RAID AutoDetect/AHCI
Boot Sequence: Boot drive that's connected to SATA0, as identified above, should be first on the boot list
Be sure to save the changes before exiting BIOS setup.
*If boot hard drive is not recognized on SATA0 port, power off, unplug and open case. Check power connection and data cable connections at both ends to the boot drive. Then go into BIOS setup again and see if the drive is recognized now. If not, then the drive may have died, as speedstep suggested.
(I'm typing this on my Dimension 8400)