Unsolved
This post is more than 5 years old
28 Posts
0
3750
SyncIQ Resync-prep fails: SyncIQ is unable to connect to a resource on the target cluster.
Hi
My environment
- Isilon X400 nodes
- OneFS 7.1.0.5
Keep getting error messages (policy name: Failovertest target: localhost) SyncIQ is unable to connect to a resource on the target cluster. Use ping to determine if target is reachable. Verify that SyncIQ is licensed and enabled on the target cluster, and that the SyncIQ daemons are running. No live connections for over 15 minutes
When i do a Resync-prep. I successfully ran a "Allow writes" on the target cluster SyncIQ policy before and added some files.
rgds
Karl Dag
Peter_Sero
1.2K Posts
1
November 11th, 2014 05:00
"target = localhost" means your sync is looping back to the source cluster,
which can make sense for testing or for duplicating data. Then you emphasize "target"
cluster as if source and target were two distinct clusters. Can you sort this out first?
-- Peter
bergec
275 Posts
2
November 11th, 2014 05:00
Look at the following KB 192503 "SyncIQ fails to create the mirror policy for failback"
Claude
Sent from my mobile device
bergec
275 Posts
1
November 11th, 2014 06:00
You should also open a case with Tech Support
Claude
Sent from my mobile device
chughh
122 Posts
0
November 11th, 2014 18:00
do you have static pool on source and target with 1gb or 10gb interface..
chughh
122 Posts
0
November 11th, 2014 19:00
http://www.ndm.net/isilon/pdf/best-practices-for-data-replication-with-emc-isilon-synciq.pdf
Also refer to best practise if something is wrong in configuration
sanadministrato
6 Posts
0
November 17th, 2014 07:00
Hi karl,
Can you send me the below output
isi_classic sync policy list -v