Unsolved
This post is more than 5 years old
51 Posts
0
1416
isilon default IPs
Hello i have an isilon with 1gb for management and 10gb for data.
When i make an isi status i can only see the management ip address.
And i just find that the synciq target cluster will by default send the IP adress of isi status.
It means today that my synciq use the 1gb network.
Do you know a way to force synciq to use the 10gb ?
I found the option force_interface but you have to modify a sysctl parameter and i can't find what to put there
regards
Martin0904
30 Posts
0
April 20th, 2016 23:00
Hi,
you can Create a dedicated IP Pool with your 10Gb Interfaces (if you want, i think any IP Pool with 10Gb will do it) for SyncIQ and then Configure your SyncIQ Policy to use only that Particular Subnet:IP_POOL. On the GUI it is Straight Forward, on the CLI i think you need --source-subnet and --source-pool.
But bear in mind, that if you Failover that Policy the First Time OneFS will create a Mirror Policy that don´t have the right Settings and you need to manipulate in Manually from the CLI
regards,
Martin
Aglidic
51 Posts
0
April 26th, 2016 00:00
so at the end we found the issue, we had dns entry for each node, and those entries was on the management network.
i don't exactly what is the answer of the target cluster but at one point synciq did a resolve and by default use the management IP.
We just remove those dns entries and everything works fine now.