Unsolved
This post is more than 5 years old
122 Posts
0
1656
Chip Set order (L502x)
Hello Rick,
Doing a manual drivers installation I am following exactly the Dell drivers order installation page, I started with ST Microelectronics Motion Sensor (as the Dell installation order page says to install that first)
I then did the 4 Chips Set listed for L502x in the order you told me last week you would use yourself.... (you can see the order I used below).
However when I installed R292780 "JMicron JMB389 Card Reader" it says "Device drive software was not successfull installed" and lists the 4 following which do not get installed until NETWORK *PCI Simple Communication Controller, *Multimedia Controller, *Network Controller and *Ethernet Controller.
Do I not worry about that error message and continue through to installing NETWORK drivers for those 4 listed, or should I not install this "JMicron" driver until after I have later installed those 4 NETWORK drivers?
Thanks
--------------
Intel Huron River (HM67)
----------------------
Renesas USB3.0 Host Controller
----------------------------
JMicron JMB389 Card Reader
---------
Intel Management Engine Interface
------------------