Can anyone tell me if the memory from PC1 in the table below will work in PC-2 which is a Latitude E6510? Thanks.
|CAS# Latency (CL)||9||7|
|RAS# to CAS# Delay (tRCD)||9||7|
|RAS# Precharge (tRP)||9||7|
|Cycle Time (tRAS)||9||7|
|Command Rate (CR)||1T||1T|
Below is the memory specs for the latitude E6510. You do not mention the other pc.
Memory Module Connector 2 DIMM slots
Memory Module Capacity 1GB, 2GB, 4GB
Memory Type DDR3 1067/ 1333 MHz
Min to Max Memory 1GB to 8GB*
A NOTE indicates important information that helps you make better use of your computer. NOTE: The computer supports a maximum of 8GB* of memory when installed with two 4GB DIMMs; however, a 32-bit operating systems, such as the 32-bit version of Microsoft® Windows® XP, can only use a maximum of 4GB of address space. Moreover, certain components within the computer require address space in the 4GB range. Any address space reserved for these components cannot be used by computer memory; therefore, the amount of memory available to a 32-bit operating system is less than 4GB. Greater than 4GB memory requires 64-bit operating systems.