Precision T5600: BIOS-Passwort zurücksetzen

Hallo,

in der folgenden Abbildung siehst du die position des PSWD Jumpers:

Zum löschen des Passworts müssen folgende Schritte durchgeführt werden (englisch):

Clearing Forgotten Passwords

1. Remove the computer cover.
2. Locate the 2-pin password connector (PSWD) on the system board.
3. Remove the 2-pin jumper plug and set the jumper plug aside.
4. Replace the computer cover.
5. Connect your keyboard and mouse, then connect your computer and monitor to electrical outlets and turn them on.
6. After the operating system loads, turn the computer off (Ensure that the computer is off and not in a power management mode. If you cannot shut down the computer using the operating system, press and hold the power button for 4 seconds).
7. Disconnect the keyboard and mouse, then disconnect the computer and monitor from their electrical outlets.
8. Press the power button on the computer to ground the system board.
9. Remove the computer cover.
10. Replace the 2-pin jumper plug onto the password connector pins(PSWD) on the system board (The password jumper plug must be reinstalled on the password jumper pins in order to enable the password feature).
11. Connect your computer and devices to electrical outlets, and then turn them on.

In System Setup, both system and administrator password options appear as Not Set. The password feature is enabled, but a password is not assigned.

Viele Grüße,

Florian