Recently I'm experiencing a major issue with my Dell monitor - 2709W, Rev A01. After few hours of usage, the screen goes black. The menu is responding ( the sensors ) and I guess it really works, but I can't see its dialog on the screen. So here are some major faults of this monitor.
1. Vertical lines, in the left side - can be corrected a bit by adding some foam over the ribbon cables.
2. The screen goes black - can't be corrected unfortunately, since I can't locate the faulty parts.
Notes: I get the blank screen, even if I remove the DVI cable.
I've read on several forums that some capacitors might be weak. Is that the case for 2709W? I've looked at the electrical board, and no swollen capacitors were noticed. What could be the cause of this issue?
After few minutes of cooling I turned the monitor back on. It works. Right now the monitor has the back cover removed and I had installed a vent to low the temps. Maybe some parts are getting too hot. I will see if this improves the situation.
It still need fixing, it's only a temporary solution. I'm afraid to get it serviced again. The last service used found no fault and fit the menu panel with the sensors inside - so stupid.
The 2709W was sold out of the UK on January 6, 2009. Warranty expired on January 5, 2012. Dell does not repair monitors, sell monitor components, or have disassembly documentation. We simply replace the whole monitor while inside the purchased warranty period and send the defective back to the manufacturer. We would not know where to start diagnosing an internal component defect.
Thank you, Chris! Meanwhile, I've installed a bigger fan, more powerful. Now the monitor runs just fine, no failures. We'll see how it goes...
I know there is a list with all the DELL monitors, on Wikipedia. All the devices have some common issues listed - here is the link en.wikipedia.org/.../Dell_monitors. Some of the comments mention low quality capacitors, bad transistors, etc. So I was wondering if this particular model - 2709W - has some bad parts which might cause screen failure.
I have some news related to "power on fault". It seems that overheat is not the issue in my case, so I will remove the fan. The monitor fails to power on ( only the LCD screen - backlight ). The menu is responding just fine, but can't see the OSD - it remains black.
So you need to plug/unplug the monitor, until you get the picture. If you manage to start it - it will remain on. No issue after that. It's obviously an issue with the electronic parts, but, till today, I didn't noticed a faulty capacitor or transistor. I'll keep looking.