Unsolved
This post is more than 5 years old
3 Posts
0
47716
U2412M, Ergotron LX arm, instructions
OK. I admit I am stupid. I am trying to attach my Dell U2412M to an Ergotron LX monitor arm. I could find no instruction on how the Dell U2412M attached in back so I started taking the back assembly off. Now I have pieces and I don't know how to re-assemble them or how to attach the monitor to the monitor arm. Does anyone know where I can obtain assembly pictures so I can either put this thing back together or attach it to the Ergotron LX arm?
Thanks in advance for any help!
DELL-Chris M
Community Manager
Community Manager
•
54.2K Posts
0
February 4th, 2013 07:00
cray1296,
All you needed to do was remove the stand from the rear of the panel to expose the four VESA mounting holes. Post some pictures of what you have done.
cray1296
3 Posts
0
February 4th, 2013 09:00
I tried emailing but received a failure notice. How do I send the photo?
cray1296
3 Posts
0
February 4th, 2013 15:00
Chris:
OK. Hopefully this will work. Sorry for my ignorance!
DELL-Chris M
Community Manager
Community Manager
•
54.2K Posts
0
February 5th, 2013 07:00
Ok, grab the the monitor panel and remove those 4 screws. Use those same 4 screws to attach the ergotron arm to the monitor panel.
HidSal
2 Posts
0
April 4th, 2018 16:00
Can I buy the entire arm assembly?
DELL-Chris M
Community Manager
Community Manager
•
54.2K Posts
0
April 5th, 2018 06:00
I assume you mean the Ergotron monitor arm.