Unsolved
This post is more than 5 years old
2 Posts
0
15073
U2414H daisy chaining question
Hi,
As far as I'm aware, there seems to be problems with daisy chaining on the U2414H for revisions before A03. Do you know if these problems may occur if you daisy chain an A03 with an A01?
DELL-Chris M
Community Manager
Community Manager
•
54.2K Posts
0
November 16th, 2015 11:00
Unknown. My guess is that if the A01 is the second in the chain and set to DP 1.2 Disabled, it should not be an issue.
imatthews
11 Posts
0
November 16th, 2015 11:00
That is not the problem. See the link below:
http://www.urtech.ca/2015/11/solved-cannot-daisy-chain-dell-u2414-or-u2415-monitors-with-surface-pro-3-on-displayport/
DELL-Chris M
Community Manager
Community Manager
•
54.2K Posts
0
November 16th, 2015 14:00
His specific question was if the primary in the chain is A03 DP 1.2 Enabled, can you then use an older revision as the secondary DP 1.2 Disabled. That link does not really discuss this specific question.
syurba
2 Posts
0
December 7th, 2015 00:00
Just a quick update. Been using the setup Chris described above and it seems to be working fine.
The only issue I've had so far is similar to this post where the monitor gets disconnected when being powered off (although in my case the resolution seems to be fine and it powers back on properly every time). It is just annoying because it moves all the windows from my secondary monitor onto my primary monitor.